Easy Fit Car Alarm

I have a car alarm fitted but its does not work properly if I want to buy and install a new myself this a good idea does anyone have advice or assistance and advice to me

Relatively easy to install, but a couple of points to consider:
You are something good that is always live and effectively connected directly to the battery, so there is no room for doubt wiring. Check all the possibilities of short circuits, especially where the son passes over / through the edges of the panel.
Think about how it would be easy to rip. Car thieves are aware of the most simple systems

An individual should be warned mechanically able to install a car alarm without too much trouble. Take your time on the installation. I would give you at least two days if you are installing several modules.

Your son + V 12 should be a heavy gauge wire and make sure to wire a fuse power for your system. Buy of the sleeve or hide your son in the wire harness factory for a villain can not see this son cut. Solder all your connections, a quality installation that does not use crimp wire, they can easily fail and allow moisture to penetrate and degrade the connection. Take your time and hide everything and its harder for a thief to see what you have installed.

Ons that I recommend:
Immobilizer
Glass Sensor
bonnet lock
Trunk lock
Door Locks

I do not recommend the GPS, because if you use them then your car has been stolen. Recovery rate is not great and there are monthly recurring charges for most systems.

DO NOT! I built my own alarm at my age there mini and everything melted. And I'm quiet as a handyman engine. I managed to mount a fan electirc, the balance of my engine, foam, put the new exhaust system, mounted a full safety cage, radio / DC, speakers and still couldnt get that sorted.

Its the theme to be wary of if you go anyway.

It's actually a simple procedure to follow instructions and take the time to run all your cables and sensors ..... If you can read you can do